Technology
Standard Wireless:
IEEE 802.11a/b/g/n/ac for Wireless LAN
IEEE 802.11i Wireless Security
Ethernet:
IEEE 802.3 for 10BaseT
IEEE 802.3u for 10/100Base-TX
IEEE 802.3ab for 1000BaseT
IEEE 802.3at for Power over Ethernet plus
IEEE 802.11ac Wave 1 Wireless LAN
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1Q for VLAN
Highest Data Rate:
IEEE 802.11a, g: 54 Mbps
IEEE 802.11n: 300Mbps @ 40MHz
Interface
Ethernet Port 2x 10/100/1000Base-T RJ-45 (JetWave 3220 V3)
2x 10/100/1000Base-T M12 (JetWave 3220-M12 V3)
IEEE 802.3at PoE+ Complaint in Ethernet Port 1
Power Input 4-pin socket for Dual DC Input
Digital Input/
Output
1x Digital Input, 0: +3V max., 1: +11V~+30VDC
1x Relay Output, 1A@24VDC
Console 3-pin Diag. socket for Diagnostic/CLI
Reset Reset Factory Default after press 7 seconds
Antenna
Socket
2x SMA Female Reverse for WIFI Radio1
2x SMA Female Reverse for WIFI Radio2
Nylok pre-applied
Performance
CPU Qualcomm Atheros Processor and 802.11ac
WIFI Chipset
Operating
Frequency
5GHz Typical Band: (802.11n WIFI)
FCC: 5.170~5.250GHz, 5.735~5.835GHz
CE: 5.170~5.250GHz
(Programmable for other 5G Band)
2.4GHz Band: (802.11n WIFI)
FCC : 2.412~2.462GHz
CE : 2.412~2.472GHz
(Programmable for different country regulations)
RF
Modulation
802.11a/n: OFDM (BPSK, QPSK, 16-QAM, 64QAM)
802.11g/n: OFDM (BPSK,QPSK,16-QAM,64QAM)
RF Output
Power (Max.
of Avg.)
5.8GHz Band:
19dBm@ 802.11a/n HT20 (MCS0/8, 5180MHz) for
FCC
23dB EIRP for ETSI 301 893 (Band 1)
25dB EIRP for ETSI 301 893 (Band 4)
2.4GHz Band:
21dBm at 802.11g/n HT40 (MCS0/8, 2422MHz) for
FCC
20dB EIRP for CE (ETSI 300 328)
(Controllable for different country regulations)
Sensitivity 5 GHz Band:
802.11a:
-90dBm@6Mbps,1Rx; -75dBm@54Mbps,1Rx
802.11n HT20:
-90dBm@MCS0,1Rx; -71dBm@MCS7,1Rx
802.11n HT40:
-87dBm@MCS0,1Rx; -70dBm@MCS7,1Rx
2.4 GHz Band:
802.11b:
-94dBm@1Mbps,1Rx; -90dBm@11Mbps,1Rx
802.11g:
-92dBm@6Mbps,1Rx; -75dBm@54Mbps,1Rx
802.11n HT20:
-91dBm@MCS0,1Rx; -72dBm@MCS7,1Rx
802.11n HT40:
-88dBm@MCS0,1Rx; -70dBm@MCS7,1Rx
Power Requirements
Power Ethernet 1: IEEE802.3at PoE+ compliant
Cables: 2/4-pair UTP/STP Cat. 5E cable (100m)
DC Input: Dual 24V (12~48VDC) input
Power
Consumption
Max. 10 Watts @ DC 48V, depend on Radio TX
power
Default WIFI Antenna Characteristics
Gain Default Antenna 5G 3.57dBi, 2.4G 2.63dBi,
Frequency Available for 5G/2.4G band
Direction Omni-Antenna
Material Fiberglass
Management
Management Web GUI, Korenix View Utility, SNMP, NTP, IP
Setup, DHCP Server/Client, Management VLAN,
Configuration Backup/Restore, Reload Default
Operating Mode System: Bridge or Router
Wireless:
Wireless Access Point, Wireless Client
WDS-AP, WDS-Client
Redundant AP, Redundant Client for wireless
redundancy
Central
Management
Standalone/ Controller-Based Mode
Radio Radio Bandwidth Control, Output power,
Antenna number
WLAN Setup Multiple SSID, Radio On/Off, SSID Broadcast,
Frequency/Channel Select, Data Rate, VLAN ID,
Advanced Settings, Maximum Client number
Link Integration Wire and Wireless Link Fault Pass-Through
WMM WMM QoS
Traffic Shaping Downstream/ Upstream Traffic Limit
Router Static, DHCP, LAN/WAN IP, IP/Port Filtering
STP Support Spanning Tree Protocol
SNMP Simple Network Management Protocol
v1/v2c/v3, Function-based MIB
MIB Function-based Management Information Base
for SNMP Management
Status Wireless Status, Associated client, Ping, Site
Survey, Ping Watchdog
Link Test Antenna Alignment Tool
Data Rate Test
SNMP Trap SNMP Trap to specific server
SMTP E-mail Alert
System Log System events log
Security
Security Multi-SSID (up to 8x ESSID for each radio)
Secured Access HTTPS, SSH, IEEE 802.1X, MAC Address ACL
Firewall Inbound/outbound firewall for IP/MAC filtering
DMZ, Port forwarding
VPN IPsec, OpenVPN
Security
Encryption
WEP 64/128 bits, WPA-PSK(TKIP), WPA2-
PSK/EAP (IEEE 802.1x/RADIUS, TKIP and AES)