JetWave 3320 Industrial UMTS/HSPA+ plus 802.11n 2T2R MIMO Wireless IP Gateway

JetWave 3320 Industrial UMTS/HSPA+ plus 802.11n 2T2R MIMO Wireless IP Gateway

Modular Time- and Frequency Synchronization System for Industrial Applications in DIN Rail Chassis

The full-featured DIN railmount package has one power supply slot, a clock module slot, a CPU slot and two slots for additional input and output modules. Both, wide range AC and a 20-60 V DC power supply model are available.



  • Single/Dual/Triple RF configurable : 802.11a/b/g/n and 2.4G/5G
  • Superb performance : 3RF with 1 GbE up to 350Mbps
  • Strong TX output power extends distance and coverage
  • High RX sensitivity enhances receiving signal quality
  • 2×2 MIMO doubles data rate
  • Supports Super Roaming, Mesh, and Mobility mode (2800-M)
  • Supports high performance multiple hopping mode (2800-H)
  • Wireless QoS (WMM) for video precedence transmission
  • High gain weatherproof fiberglass antenna by selection
  • IP67 aluminum housing, -35~70°C outdoor solution

Additional information

Key Features

Standard Wireless:
IEEE 802.11a/g/n for Wireless LAN
IEEE 802.11i Wireless Security
IEEE 802.3 for 10BaseT
IEEE 802.3u for 10/100Base-TX
IEEE 802.3ab for 1000BaseT
IEEE 802.3at for Power over Ethernet
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1Q for VLAN
Highest Data Rate:
IEEE 802.11a, g: 54 Mbps
IEEE 802.11n: 300Mbps @ 40MHz
Ethernet Port 2x 10/100/1000Base-T RJ-45 (JetWave 3320)
2x 10/100/1000Base-T M12 (JetWave 3320-M12)
IEEE 802.3at PoE Complaint in Ethernet Port 1
Power Input 4-pin socket for Dual DC Input
Serial 1x RS-232/422/485, 2-pin DIP for 120ohm long
distance resistor for long distance RS485
Digital Input/
1xDigital Input, 0: +3V max., 1: +11V~+30VDC
1xRelay Output, 1A@24VDC
Console 3-pin Diag. socket for engineer
Reset Reset Factory Default after press 7 seconds
SMA type for 3G/GPRS, WIFI
CPU 680MHz
Memory 16MB Flash
5GHz Typical Band: (802.11n WIFI)
FCC: 5.170~5.250GHz, 5.735~5.835GHz
CE: 5.170~5.250GHz
(Programmable for other 5G Band)
2.4GHz Band: (802.11n WIFI)
FCC : 2.412~2.462GHz
CE : 2.412~2.472GHz
(Programmable for different country regulations)
802.11a/n: OFDM (BPSK, QPSK, 16-QAM, 64QAM)
802.11g/n: OFDM (BPSK,QPSK,16-QAM,64QAM)
RF Output
Power (Max.
of Avg.)
5.8GHz Band:
21dBm@ 802.11a/n HT20 (MCS0/8, 5180MHz) for
23dB EIRP for ETSI 301 893 (Band 1)
25dB EIRP for ETSI 301 893 (Band 4)
2.4GHz Band:
21dBm at 802.11g/n HT40 (MCS0/8, 2422MHz) for
20dB EIRP for CE (ETSI 300 328)
(Controllable for different country regulations)
Sensitivity 802.11a:
-82dBm@6Mbps,1Rx; -95/-91dBm@6Mbps,2Rx;
-65dBm@54Mbps,1Rx; -79/-75dBm@54Mbps, 2Rx;
-82dBm@6Mbps,1Rx; -95/-91dBm@6Mbps,2Rx;
-65dBm@54Mbps,1Rx; -80/-76dBm@54Mbps,2Rx
802.11a/n HT20:
-82dBm@MCS0,1Rx; -95/-91dBm@MCS8,2Rx;
-64dBm@MCS7,1Rx; -77/-73dBm@MCS15,2Rx
802.11a/n HT40:
-79dBm@MCS0,1Rx; -91/-87dBm@MCS8,2Rx;
802.11g/n HT20:
-82dBm@MCS0,1Rx; -95/-91dBm@MCS8,2Rx;
802.11g/n HT40:
-79dBm@MCS0,1Rx; -90/-86dBm@MCS8,2Rx;
3G Cellular
Quad band, 850/900/1800/1900MHz
UMTS/HSPA+: Five band,
HSPA Standard: 3GPP Release 6/7
Data Rate: DL 14.4Mbps, UL 5.7Mbps
UMTS Standard: 3GPP Release 4
Data Rate: PS 384kbps DL/ 384kbps UL
*Check User manual for detail specification
Power Requirements
Power Ethernet 1: IEEE802.3at PoE+ compliant
Cables: 2/4-pair UTP/STP Cat. 5E cable (100m)
DC Input: Dual 24V (12~48VDC) input
Max. 10 Watts @ DC 48V, depend on Radio TX
Default WIFI Antenna Characteristics
Gain Default Antenna 5G 3.57dBi, 2.4G 2.63dBi,
Frequency Available for 5G/2.4G band
Direction Omni-Antenna
Material Fiberglass
Management Web GUI, Korenix View Utility, SNMP, IP Setup,
DHCP Server/Client, Management VLAN, NTP,
Configuration Backup/Restore, Reload Default
Operating Mode System: Bridge or Router
Access Point, Client, WDS-AP, WDS-Client
Radio Radio Bandwidth Control, Output power,
Antenna number, Distance in Meter
WLAN Setup Multiple SSID, Radio On/Off, SSID Broadcast,
Frequency/Channel Select, Data Rate, VLAN ID,
Advanced Settings, Client Based Fast Roaming,
Maximum Client number
Link Integration Wire and Wireless Link Fault Pass-Through
WMM WMM QoS Traffic
Shaping Incoming/Outgoing Traffic Limit
Router Static, DHCP, LAN/WAN IP, IP/Port Filtering
STP Support Spanning Tree Protocol
SNMP Simple Network Management Protocol
v1/v2c/v3, Function-based MIB
Status Wireless Status, Associated client, Ping, Site
Survey, Ping Watchdog
Link Test Antenna Alignment Tool
Data Rate Test
SNMP Trap SNMP Trap to specific server
SMTP E-mail Alert
System Log System events log
Serial Serial Mode RS-232/422/485 Selection,
Baud Rate, Serial parameters settings,
TCP Server, TCP Client, UDP mode
3G 3G Connect, 3G Status, Debug log download
SIM Security, Auto IP report
Redundant 3G/WAN Redundant
GPS GPS Positioning(Phase 2)


Share this page